Ninja update

So I stared to do some work on the bike. A few surprises that I found are

• small bent in the rear rim
• the po jacked with the sprocket bolts and they are all stripped...

The problems that I was aware were

• low beam is out
• rear tire needed replacement
• chain and sprockets needed to be replaced
• front and rear brake pads need to be replaced

Of course, I would do the typical "just bought" maintenance, like oil/filter change, cable lube, coolant flush, replacing air filter, etc.

So my solutions so far are

• ordered sprocket/chain set from ebay.  I am going up one teeth on front to lower the hwy rpm.
• ordered a rear wheel with 1,000 miles.  this strait rim will come with sprocket and tire.

Both of these should come in sometime this week.