Installing BLASTER-X Control Switch

The last thing I needed to install for the Custom LED integrated tail light was the Blaster X Control Switch. Installation was very simple. It was a bit tricky to find the best place to install the switch.

Here is the picture of the switch. The gray end of the wire goes to the gray wire of the tail light. And the black goes to any ground on the bike.

1. Connect the cable - solder and heat shrink
   
   
   Don't pay attention to the wiring on the card board. I just needed some white background.
   
   
   In this picture the switch is in "ON" position.
   
   
2. Connect the black end to the frame.
   Found the perfect spot for the ground.  Use 10mm socket for the bolt.
   
   
   And the bolt fits PERFECTLY.
   
   
   I routed the wire like this.
   
   
3. Use 1 inch Rubber Insulated Cramp to install the switch under the front seat on the right side.
   
   
   Found this clamp at HomeDepot.
   

Lastly, I wasn't 100% happy with the way the tail light was fitting onto my bike. So while at HomeDepot, I bought two 3/8 plastic washers and put them in between the unit and the frame. It fits much better now.